Nitrogen Oven LB-30NTO Catalog

Labotronics Nitrogen Oven LB-30NTO delivers heating of items in a nitrogen filled chamber, reaching up to 200 degrees Celsius. The nitrogen purge oven offers a nitrogen inlet with filter plus pressure regulator, a flow meter reading up to 100 liters per minute, forced horizontal air circulation, PID control with a live set value display, a timer, a 304 stainless steel interior with four wire mesh shelves, over temperature protection. The n2 oven is used in materials testing, electronics, or chemical laboratories, where this nitrogen oven equipment supports thermal processing of oxygen sensitive materials.

Capacity	480 L
Shelves	4 wire-mesh shelves, 4 levels
Temperature Range	Ambient +20 °C to 200 °C
Temperature Control Precision	±1 °C
Temperature Uniformity	±2.0 °C
Heating Rate	Approx. 15 minutes to 100 °C from ambien
Temperature Controller	PID microprocessor, PV/SV dual display, keypad entry
Temperature Sensor	K-type thermocouple
Current Control	Solid-state relay (SSR), 12 V output
Heating Element	Stainless steel heater
Timer Range	99.9 seconds to 999 hours
Air Circulation	Forced horizontal, long-shaft motor, multi-blade fan, adjustable baffles
Nitrogen Flow Meter	0 to 100 L/min
Inner and Middle Layers	1.2 mm 304 stainless steel, fully sealed welds
Exterior	1.2 mm SECC steel plate, powder-coated
Insulation	Imported rock wool
Door Gasket	High-temperature silicone
Internal Dimensions (W × H × D)	800 × 1000 × 600 mm
External Dimensions (W × H × D)	1060 × 1480 × 800 mm
Power Supply	3-phase 380 V
Net Weight	350 kg
Gross Weight	650 kg

1.Nitrogen inlet with flow meter
2.Nitrogen filter and pressure regulator
3.PID microprocessor temperature control
4.Forced horizontal air circulation
5.Stainless steel inner chamber
6.Timer with alarm
7.Swivel casters with fixed leveling feet
8.Safety protection: overtemperature, phase-loss and overload

Accessory No	Accessory	Quantity
1	Electrical heater	1 piece
2	Non fuse switch	2 piece
3	3 meter power cord	1 piece
4	Tray stand	2 piece
5	Timer	1 piece

Electronics → Oxygen-free drying and curing of components
Chemical Laboratories → Drying of oxidation-sensitive samples
Material Research Laboratories → Heat treatment of materials under nitrogen

 Oxygen Meter